KREOLAB PHOTOGRAPHIC LABORATORY SYSTEMS AND EQUIPMENT
Photographic Sinks for Film Developing
Sinks are of a one-piece molded glass-fiber reinforced resin construction. This resin was specifically
developed to be impervious to the corrosive effects of rapid fixers, color bleaches, iron chloride and other
harsh chemicals used in photographic and graphic arts processes. We have never had a rusty sink. There are many Kreolab sinks in service which are in their third, fourth, or fifth decade of service. How do we know that? Because we get calls for plumbing parts for those sinks, and we are able to furnish those parts.
Sinks are pre-plumbed at the factory and delivered ready for installation. Plumbing packages are chosen to
suit the application, and fixtures include appropriate water temperature blenders, water filters, faucets with
hoses, vacuum breakers, standpipes and basket strainers. Controls are positioned for optimum
handicap accessibility. All Kreolab stands and cabinets are laminated plywood.
10 INCH DEEP TANK PROCESSING SINKS FOR PHOTOGRAPHIC FILM DEVELOPING
Sink on Cabinet w/ plumbing pkg.
Sink on cabinet, no plumbing pkg.
Sink on Stand w/ plumbing pkg.
Sink on Stand No Plumbing Pkg.
Inside Sink Dimensions
Floor Space Width X Length
17 X 21
24 X 24
17 X 33
24 X 36
17 X 45
24 X 48 **
17 X 48.5
24 X 51.5
25 X 36.5
32 X 39.5
25 X 48.5
32 X 51.5
25 X 60.5
32 X 63.5
25 X 72.5
32 X 75.5
** Drainboard on right side
*** 36 inch sinks can not have KR100 chiller installed inside cabinet or stand.
What is the purpose of plumbing packages?
Plumbing packages are used for temperature control on photo processes that require critical temperature control.
Incoming water is blended to the proper temperature and circulated by jets around the tanks in the sink. This keeps
the tanks at the proper temperature. Many photographic processes require developement at a controlled
temperature for a specific time. In some parts of the country, incoming cold water temperatures may reach 86-90
degrees in the summer; if lower developing temperatures are required, a chiller must be installed in order to
maintain the proper temperature.
Kreonite Sinks with Model Number E1 and E2 are equipped with the following standard equipment installed and interconnected.
1 each KTB251 - WATER TEMPERATURE BLENDER - Jet inlets, blended water, valve,
jet control, vacuum breaker, and thermometer.
1 each K220S - FAUCET, two valve. Hot water valve, Cold water valve and spray hose.
1 each KWFP - WATER FILTER PANEL, HOT & COLD 25 MICRON WATER FILTERS WITH SHUT-OFF VALVES
1 each KFC110VB - FAUCET, single valve,. Vacuum breaker, KSE3 spout end for hose attachment, blended and filtered water from KTB250 blender.
1 each KSP1 - Combination 1 inch STANDPIPE and BASKET STRAINER when inverted.
One piece molded Kreonite sink 10" deep with 5" utility ledge on 7" high backsplash
with the drain channeled bottom. Includes installed 1.5" drain with combination strainer, 1" standpipe and 7" tailpipe.
Factory installed plumbing fixtures, accessories, and support systems are priced separately. See Accessory Section.
ALL KREONITE SINKS WILL INCLUDE A KREOLAB STAND OR CABINET